Hot Water Heater Pilot Light. This can be extremely dangerous for you and your family. Pilot mode is essential because it keeps your hot water system safe from carbon monoxide poisoning.
Pilot Light On A Hot Water Heater Stock Photo Image of broken, pipes from www.dreamstime.com
It’s normal and fine for the pilot light to go out once in a while. Then, push the button back down and hold it down for about five minutes. It usually occurs with an old water heater but problems can happen with new units as well.
A Water Heater Pilot Lights But Not The Burner If The Thermostat Is Damaged Or Over 10 Years Old.
Whenever this light goes out, the water in your hot water tank will start to cool. It might be the reason why your furnace pilot light keeps going. To properly light the pilot, first turn off the gas to the water heater.
You’ll Want To Press And Hold The Knob Down.
Remove the access panel to access the burner. Once the pilot is burning well, release the knob and turn it to the ‘on’ setting. If your gas water heater has an igniting button, press that instead.
Straighten All Kinks On The Flex Tube.
It’s also wise to look for any visible damage that might cause gas leaks. Flame sensors can fail if they are dislodged and the burner won’t detect the pilot light’s flame. If any of these problems arise, then you will want to contact a professional immediately.
Unscrew The Thermocouple, Pilot Tube, And Manifold Tube.
Things you need for this tutorial. It usually occurs with an old water heater but problems can happen with new units as well. For the thermocouple, remove the wires from the thermal switch.
Now The Water Heater Pilot Light Should Be Burning Smoothly.
Release the reset button (s) slowly to make sure the pilot light stays lit,. Remove the two screws that hold the burner in place, using a screwdriver. The recommendations in this article should help you troubleshoot these problems or help you understand the actual cause of the issue.
Post a Comment for "Hot Water Heater Pilot Light"